cable length造句

• It is important for the cable length to be suitable for the depth of the hole concerned .
  脚线的长度要适应于炮眼的深度，这一点是很重要的。
• Measurement of fiber or cable length using an otdr
  利用otdr进行纤维和光缆长度测量
• Otdr measurement of fiber or cable length using an otdr
  利用光时域反射计
• Cable type : cable length l m
  缆式：电缆长度l米
• Cable length compensation
  视频电缆长度补偿
• Camera cable length
  摄像机数据线长度
• Cable length meter
  线缆计米器
• 12vdc car plug input and usb plug output . cable length : 22 in extendable to 4 ft
  12vdc汽车电压输入， usb输出插口，接线长度22寸，可伸至4尺。
• Alternative resistance ratings , rated temperatures , resistance tolerance and cable lengths available on request
  按客户要求设计电阻值额定温度电阻公差及电缆线长度
• Place the units in their intended mounting locations to check the cable length and monitor installation conditions
  把设备放入计划好的安装位置，检查电缆长度和监视器安装条件。
• The problem is magnified with cable lengths over 1 meter in length . some equipment is less sensitive to this ; some very touchy
  如果线的长度超过1米的话这种问题更为明显。某些器材对连接线不是很敏感，但有一些却很难搭配。
• Based on the parabola and catenary theories , calculation formulas on the cable length are summarized , and the precision is discussed
  摘要以抛物线和悬链线理论为基础，总结推导了悬索索长的实用计算公式，对各公式的计算精度进行了分析。
• And analyzed the resonance over - voltage with a typical power - distribution - net model , the result showed that cable length and load value could avoid the resonance over - voltage
  并对典型的现代配电网进行了谐振过电压分析计算，明确了现代配电网的谐振过电压与电缆长度和负荷的大小相关。
• After obtaining the whole loads we optimize cable tension by means of controlling cable length on the basis of influence matrix method . practical examples are presented to illustrate the process and efficiency of the method
  然后利用影响矩阵的概念，令索力为受调向量，索长为施调向量，通过控制各索的长度来调整优化索力。
• The stripping cable length should comply with the design requirements ; after cable stripping , carefully examined whether fiber cable and cannola has injury or not , after inspect to be flawless before the installation of connector box
  接续时开剥光缆长度要符合设计要求；光缆开剥后，仔细检查松套管和光纤有无损伤，经检查无误后方可安装接头盒。
• This paper presents three basic principles for the location of the equipment room . that is environment priority , the shortest cable length and the small ball adjustment principle , and it focuses on the shortest cable length principle
  摘要本文对设备间位置的优化提出了三个基本原则，重点论述了网络总长度最短原则，并探讨了一些实现网络总长度最短的具体方法。
• For example , power loss of approximately 3 % is expected between an individual service point and common feeding facilities where the measurement will be taken , although such loss is dependent upon the capacity and cable length of each system
  例如，虽然此类损耗取决于各系统的能力与电缆长度，但在单个应用点与公用进料设施（将在此处测量）之间的功率损耗预计大约为3 % 。
• Above cable data for standard motors only , with cable length of 25 ' . data applicable through lengths of 100 ' . 140 frame motors with # 16 awg cord utilize single cable , ( 8 ) conductor , with power and control leads
  上列电缆参数仅适用于标准电机，长度为25英尺。可提供的电缆长度最大为100英尺。符合# 16awg标准的140机架电机采用实用的单芯电缆， （ 8 ）导线，配置电源和控制引线。
• And more , the inverse kinematics model on this cable and cabin system is developed according to the kinematics theory of robot ; since the cable and cabin structure is a parallel mechanism instead of series system , both cable length and speed are required to be controlled
  大射电望远镜悬索式馈源支撑系统从理论上说属于并联机构学的研究范畴，国内外关于这种新型机构的研究目前仍然处于探索阶段，尚没有形成系统的理论与方法。
• According to the problem in cable tension monitoring that the damper set on cable will reduce the accuracy of cable tension measurement , an updating method was advanced to identify the computational cable length through the theoretical cable tension . and then , the relatively reliable measured cable tension could be obtained
  针对索力监测中由于减震器的设置影响索力测量准确性的实际问题，本文提出了依据理论预测索力对实际计算索长进行整体辨识的方法，从而得到相对可靠的索力测量修正值。